IP ratings on a snowflake projector, decoded

Every outdoor snowflake projector lists an IP rating, and the number tells you how much rain, snow and dust it is built to shrug off. The catch sits in the small print, because the plug is often rated lower than the projector.

Two digits, two kinds of protection

An IP rating comes from the international standard IEC 60529. The first digit rates protection against solids such as dust, and the second rates protection against water.

The higher each digit, the tougher the seal, and a 6 in the first place means dust-tight. The IP code article lists every level if you want the full scale.

RatingWater protectionWhat it suits outside
IP44Splashing from any directionRain on a covered porch; borderline in open weather
IP65Low-pressure water jets, and dust-tightRain and snow from any direction
IP67Temporary immersion up to 1 m for 30 minutes, and dust-tightA projector that may end up standing in a puddle

The rating describes a new, closed unit. A cracked housing or a loose cable entry doesn’t keep its number, so look the projector over before each winter.

Which rating each projector carries

ProjectorProjector bodyPlug or adapter
GUSODOR SW-TY-002IP65IP44 plug
LILNIAGY HT-TY-10IP65 housingIP44 adapter
Forlivese triple-headIP65Not stated separately
Govee H7071IP67Not stated separately
LYHOPEIP44Not waterproof, per the listing
Brightown topperIndoor onlyUL-certified plug with transformer

Read both columns. A projector with an IP65 body and an IP44 plug keeps out no more water than that plug, which is why the connection belongs in a covered box whatever the head says.

The full specs for all six sit in the comparison table on the homepage. Weather rating is one row there, next to coverage, distance and controls.

How to read a listing’s weather claims

Titles love the word “waterproof”, and it tells you little on its own. Look for the two digits in the bullets or the spec table, and check whether they belong to the projector, the plug or both.

The better listings split them out. The GUSODOR bullets say IP65 casing and IP44 plug, and the LILNIAGY spec table lists UL, IP65 and IP44 side by side, which only makes sense once you read the bullets that pin IP44 on the adapter.

Where a listing gives one number for the whole kit, assume it describes the projector head. Treat the adapter as the weaker part until the seller says otherwise.

IP44, fine under a roof

IP44 protects against splashing from any direction. That covers rain blowing onto a covered porch, but a projector standing in an open lawn through a storm sits at the edge of what the rating promises.

The LYHOPE is the IP44 model in our lineup. Its listing says the adapter is not waterproof and asks for a weatherproof outlet cover, a good reason to place it under an eave or a porch roof.

IP44 is also the usual rating for the plugs and adapters of IP65 projectors. On most setups the weak point is the box by the outlet, not the projector in the lawn.

IP65, the outdoor standard

IP65 means dust-tight and protected against low-pressure water jets. In practice that handles rain and snow from any direction, which is what a projector on a lawn stake faces for weeks on end.

Both plain double-heads, the GUSODOR and the LILNIAGY, rate their projectors IP65, and so does the Forlivese triple-head. The Forlivese also lists a working range of 5 °F to 95 °F (−15 °C to 35 °C), the only temperature range among our picks.

Head count has no effect on the seal. A triple-head and a double-head can share the same IP65 rating, so our guide to double or triple-head projectors picks between them on coverage instead.

IP67, for puddles and melting snow

IP67 adds protection against temporary immersion, up to 1 m for 30 minutes. A projector left in a puddle after a thaw, or under a drift that melts around it, is the case this rating covers.

The Govee H7071 is the only IP67 projector in our lineup. It is also the heaviest at about 5.1 lb, with a metal and plastic body and a 1-year warranty from Govee.

Owners describe it as sturdy, though some report units that stopped after a week. A tighter seal guards against water, not against every other fault.

Cold, condensation and snow

Water can get in without rain. When a projector cools after switching off, condensation can form inside the lens, and a fogged lens throws soft, blurred flakes until it clears.

Snow brings two more problems. A low projector can be buried, and a ground stake in frozen soil needs a pilot hole, so our guide to setup and mounting covers stakes, bases and raised spots.

If moisture does get in, the signs can include flicker, a dark head or a GFCI that trips. The troubleshooting guide lists what to check, from the adapter box to the timer.

  • Shelter every plug and adapter under an in-use cover or inside a weatherproof connection box
  • Raise the box off the ground, away from puddles and drifts
  • Use outdoor-rated cords with a W in the jacket code
  • Plug into a GFCI-protected outlet
  • Check the housing and lens for cracks before each winter

The wiring side of all this is in our outdoor safety guide. For the shortlist, see our pick of the weatherproof snowflake projector for each kind of yard, including the IP67 Govee at pick 4.

For open lawns and wet winters

The Govee H7071 is rated IP67, works with the Govee Home app, Alexa, Google Assistant and Matter, and carries a 1-year warranty. It sits in the top price band and is designed for about 10 ft, so it lights one feature rather than a whole house.

Questions and answers

More questions about IP ratings

What does IP65 mean on a snowflake projector?

The 6 means dust-tight and the 5 means protection against low-pressure water jets. In practice an IP65 projector handles rain and snow from any direction.

Is IP44 good enough for outdoor use?

IP44 protects against splashing from any direction, which suits a covered porch. In open weather it is borderline, so place an IP44 projector under a roof or an eave where you can.

What is the difference between IP65 and IP67?

IP67 adds protection against temporary immersion up to 1 meter for 30 minutes. That matters if the projector may sit in a puddle or in melting snow. The Govee H7071 is the IP67 model in our lineup.

Is the plug as waterproof as the projector?

Often not. The GUSODOR has an IP65 projector and an IP44 plug, and LYHOPE’s own listing calls its adapter not waterproof. Put connections under an in-use cover or in a weatherproof box.

Why is there fog inside my projector lens?

Condensation can form inside the lens when a projector cools after switching off. It may clear once the projector runs and warms again. If water collects inside, unplug it, dry it indoors and check the housing for cracks.