The snowflake projector glossary
IP65, RF remote, GFCI, throw distance: snowflake projector listings speak their own language. This page explains the 36 terms you will meet most often, each in a few sentences and backed by the figures of the projectors in our lineup.
These are the terms that keep turning up on snowflake projector listings and in their short manuals, sorted alphabetically. Each entry points to the guide that goes deeper.
The figures come from the six projectors in our best snowflake projector comparison. You can see them side by side in the comparison table on the homepage.
A
- Adapter
- The plug-in power supply between the outlet and the projector, which turns household current into the low voltage the LEDs run on. It is often the weakest seal in the setup, IP44 on the GUSODOR plug and the LILNIAGY adapter, and LYHOPE says its adapter is not waterproof at all. Keep it dry and off the ground, as our guide to safe outdoor wiring explains.
- Auto-rotation
- The small motor inside each head that turns the pattern film, so the snowflakes drift across the wall instead of standing still. The Forlivese listing calls its snowflakes auto-rotating, and the Brightown topper uses an auto-moving motor that some owners hear as a whine. When the light stays on but the motion stops, start with our troubleshooting guide.
B
- Beam angle
- How wide the cone of light leaves the lens, in degrees. The LILNIAGY spec table gives 120°, one of the few beam figures any seller in our lineup publishes. A wider beam covers more wall from the same spot but spreads the same light thinner, as our guide to projection distance shows.
C
- Ceiling projection
- Aiming the light up at a ceiling rather than at an outside wall. The Brightown star topper is built for it, sending moving snowflakes and dots over 21 to 53 sq ft of ceiling from the top of the tree. Rooms, ceilings and cords are covered in our guide to snowflakes indoors.
- Coverage area
- The wall area a seller says the pattern fills, in sq ft. Figures vary even within one listing, 30 to 500 sq ft in the GUSODOR bullets against 70 to 350 in Amazon’s own summary, while Forlivese claims 235 to 521 sq ft when placed 16 to 36 ft back. Read them as rough guides; how far away it should sit explains why.
D
- Double-head
- A projector with two heads on one body, each with its own LEDs and pattern, so you can aim them at different parts of the house. The GUSODOR, LILNIAGY and LYHOPE in our lineup all use this layout, and each GUSODOR head turns through 360°. How two heads compare with one or three is in one, two or three heads.
- Dusk-to-dawn sensor
- A light sensor that switches a fixture on when it gets dark and off at daylight. None of the six listings in our lineup mentions one; they rely on a 6-hours-on, 18-hours-off cycle, a remote timer or an app schedule instead. Our guide to timers, remotes and apps explains how each one behaves.
E
- ETL listing
- A safety mark from the testing company Intertek, accepted as an alternative to a UL listing for most household electrics in the US. None of the six listings in our lineup claims one, so the marks you will meet there are UL claims. What to look for on the box and the adapter is in our projector safety guide.
F
- Focus
- How sharp the edges of each snowflake look on the wall. Most cheap projectors have a fixed lens, so the only focus control is distance, and moving closer gives smaller, crisper flakes. The Govee H7071 uses a focusing lens, though Govee warns its ripple lens causes some color dispersion; our guide to sharper snowflakes goes further.
G
- GFCI
- Ground-fault circuit interrupter, a device that cuts the power almost instantly if current leaks to ground through water or a person. Under the National Electrical Code, the outdoor receptacles of homes need GFCI protection, and the ESFI advises plugging outdoor decorations into one. The rest of the wiring is in our outdoor safety guide.
- Ground stake
- The spike that holds a projector upright in the lawn. The GUSODOR, LILNIAGY, Forlivese, LYHOPE and Govee all come with or take one, and frozen ground needs a pilot hole before you push it in. Placement and angle are covered in where to set it up.
I
- In-use cover
- A weatherproof outlet cover, often called a bubble cover, that closes over the receptacle while a cord is plugged in. LYHOPE tells buyers to use one because its adapter is not waterproof, and it helps any projector whose plug is rated lower than its head. Our guide to IP44, IP65 and IP67 explains why the plug matters.
- IP rating
- The ingress protection code from IEC 60529, two digits that say how well a casing keeps out solids and water. The first digit covers dust and the second water, so IP65 means dust-tight and safe against low-pressure jets. The IP code article lists every level, and our guide to weather ratings applies them to projectors.
- IP44
- Protection against splashing water from any direction, fine for rain on a covered porch and borderline in open weather. The LYHOPE projector is rated IP44, and so are the GUSODOR plug and the LILNIAGY adapter. Raise and cover anything with this rating, as our weather rating guide shows.
- IP65
- Dust-tight and protected against low-pressure water jets, so rain and snow from any direction are fine. The GUSODOR, LILNIAGY and Forlivese projectors are rated IP65, which is the norm in the $ and $$ bands. The weakest seal still sets the limit, though, as our guide to a cheap snowflake projector explains.
- IP67
- Dust-tight and able to survive temporary immersion up to 1 m for 30 minutes, which in a yard means a puddle or a snowmelt. In our lineup only the Govee H7071 carries it. Our GUSODOR and Govee comparison weighs that sealing against a cheap IP65 double-head.
- IR remote
- An infrared remote, like most TV remotes, which needs a clear line of sight to the projector. That makes it awkward for a projector out on the lawn while you sit indoors. Compare it with an RF remote in our guide to timers and remotes.
L
- Laser projector
- A projector that uses laser diodes instead of LEDs and is regulated as a laser product. None of the six in our lineup is a laser; they all put an LED behind a patterned film. Never aim any projector at the sky, where pilots can be dazzled (the FAA covers this), and see how projectors differ from strands in projector or string lights.
- LED beads
- The individual LEDs inside the heads. The GUSODOR has 12 across two heads, the Forlivese 18 across three and the Brightown topper 4, while the LILNIAGY lists 12 in its bullets and 8 in its spec table. Bead count is no brightness rating; our page on one, two or three heads covers what more heads add.
- Low voltage
- Power below household voltage, delivered by the adapter to the projector. The LYHOPE runs on a 13.5 V adapter that its listing calls UL-certified, so the lead to the projector carries low voltage. The adapter itself still sits on household power, which is why our safety guide wants it dry and off the ground.
- Lumens
- The total light a source puts out. Sellers of snowflake projectors rarely publish a lumen figure, and none of the six listings in our lineup gives one. Without it, distance, full darkness and a light-colored wall decide how bright the flakes look, as our guide to sharper snowflakes explains.
M
- Matter
- A smart-home standard that lets devices from different brands work in the same app or voice assistant. The Govee H7071 supports it alongside the Govee Home app, Alexa and Google Assistant, the only projector in our lineup to do so. How it compares with a remote or a plain timer is in our guide to timers, remotes and apps.
- Motion mode
- The setting in which the pattern moves, so snowflakes drift or fall across the wall. Every projector in our lineup is sold on moving snowflakes, and the Govee adds 58 scene modes in its app. Movement is what sets a projector apart from a strand of lights, as our page on projector or string lights shows.
O
- Outdoor-rated cord
- An extension cord rated for the load you plug into it and marked for outdoors, which shows as a “W” in its jacket code, as in SJTW. Keep plug-and-cord connections off the ground and out of puddles, and never pinch a cord in a door or window. The GUSODOR’s own cord runs 16.4 ft; the rest of the wiring is in our projector safety guide.
P
- Pattern disc
- A swappable slide that sets the image a projector throws. The Govee H7071 comes with 20 of them, changed by hand rather than automatically, and owners find them awkward to swap; the cheaper projectors use a fixed film inside each head. Our GUSODOR and Govee head-to-head weighs discs against a snowflake-only projector.
- Projection head
- The unit that holds the LED, the pattern film and the lens, and that you aim at the wall. Each GUSODOR head turns through 360°, and the single Govee head tilts through 180°. Head count shapes coverage more than anything else, as our page on one, two or three heads explains.
R
- RF remote
- A radio-frequency remote, which works through walls rather than needing line of sight. The GUSODOR listing says its RF remote reaches about 33 ft through walls and 66 to 98 ft in the open, though the AAA battery is not included. Many RF remotes need pairing on first use; our guide to timers and remotes has the details.
S
- Smart app
- A phone app that switches the projector, sets its schedule and picks its scenes. In our lineup only the Govee H7071 has one, the Govee Home app, which holds its timers and 58 scene modes. Whether an app beats a remote for your house is the question our guide to timer, remote or app answers.
- Static mode
- A setting that holds the pattern still instead of moving it. The listings in our lineup sell their projectors on moving snowflakes and say little about a still setting, so check the listing if you want one. If the pattern freezes when you didn’t ask it to, the motor may be at fault, and our troubleshooting guide goes through the causes.
T
- Throw distance
- The distance from the lens to the wall. Doubling the distance stretches the same light across four times the area, the inverse-square law, so flakes grow bigger but dimmer. The listings give about 33 ft for the GUSODOR, 16.4 to 33 ft for the LYHOPE and about 10 ft for the Govee; our guide to projection distance sets them side by side.
- Timer cycle
- A built-in repeating schedule, usually 6 hours on and 18 hours off, found on the GUSODOR, Forlivese and LYHOPE. It counts from the moment you switch on, so switch on at dusk, and after a power cut it restarts from when power returns. Our guide to timers and remotes covers resetting it.
- Triple-head
- A projector with three heads on one body. The Forlivese in our lineup has three heads with 18 LED beads and, at 235 to 521 sq ft, the widest rated spread of our six. Whether the third head earns its place is the subject of one, two or three heads.
U
- UL listing
- A safety mark from UL showing a product was tested to the relevant standard. Read the claim closely, since the LILNIAGY spec table calls the projector UL listed, while LYHOPE and Brightown claim it for the adapter or plug only. Our page on snowflake projector brands covers what each listing says.
W
- Wall mount
- Fixing the projector to a wall, a post or a fence instead of staking it in the lawn. The GUSODOR comes with a bracket and 3 screws, the LYHOPE with wall screws, and the Govee with a mounting plate. A raised spot keeps the projector clear of snow, as our guide on where to set it up explains.
- Wattage
- The power a projector draws. The LYHOPE uses 6 W and the Govee H7071 20 W, so a 6-hour night costs 36 Wh against 120 Wh, and the LYHOPE comes to roughly 16 cents a month at an example 15 cents per kWh. Running costs are covered in our guide to a cheap snowflake projector.
- Weatherproof box
- A closed plastic box that holds a plug-and-cord connection or an adapter off the ground and out of the rain. It is the simplest fix for an IP44 plug on an IP65 projector, and it keeps snowmelt away from the connection. Where to put it is shown in our guide on setup and mounting.